No."General syntax or operator from TERMINAL\ 17.05.93          "
001" Illegal character!\                                        "
002" Unknown command in manual mode!\                           "
003" Not all required fields are programmed!\                   "
004" Input value outside limits %s and %s!\                     "
005" Wrong speed or no entry!\                                  "
006" Wrong position or no entry!\                               "
007" File %s does not exist!\ Program                           "
008"Error initializing: insufficient memory!\  Strtup           "
009" Interpreter %s: error in header: %s\                       "
010" Interpreter %s: wrong index. line: %s\                     "
011" Interpreter %s: wrong value. line: %s\                     "
012" Edited program number outside %s and %s!\ NC-PROG          "
013" NC program: illegal command!\  ErrNCIllgCmd                "
014" NC program: index outside %s and %s!\ ErrNCIllgIndex       "
015" NC program: input value outside %s and %s!\ NC prog        "
016" NC program: illegal character!\   NC prog ErrNCIllgChar    "
017" NC program: illegal operator!\  NC prog ErrNCIllgOper.     "
018" NC program: hex byte outside 00 and FF!\ NC prog           "
019" NC program: output number outside 0 and 7!\     NC prog    "
020" CAN outputs from 010 to 017 not supported yet!\            "
021" Program: invalid assignment!\ NC prog                      "
022" Input values outside 0 and 7!\        NC prog              "
023" Line numbers not in ascending sequence!\ NC prog           "
024" After the END command further lines were edited!\          "
025" Servo module: NACK received! Error code: %d!\ UNIT SERVOMOD"
026" Servo module: check byte: calculated: %2x, received: %2x!\ "
027" Program: error in comment or too long (max. 20)!\          "
028" Program: no END command was edited!\ NC prog               "
029"ERROR: configuration file 'INFOS.DAT' not found!\ Init      "
030"ERROR: configuration file: not all data defined!\           "
031"Syntax error in config. file (axes, COM or language)!\      "
032"Status request was not acknowledged by axis!\ Idle          "
033"Syntax error in received status message!\ Idle              "
034"ERROR: Printer not ready!\                                  "
035"FATAL ERROR! Axis not ready! Stop operation!                "
036"ERROR: Axis %2d does not exist!\  P. SlctActAxis            "
037"ERROR: Error info not read by axis!\LU                      "
038"Program: Illegal characters at line end!\ NC program        "
039"Read file fault %s!\ Gen. File Read Error                   "
040"Write file fault %s!\ Gen. File Write Error                 "
041"Error in encoder data: Encoder list error                 #1"
042"Pulse train length outside of %d and %d!\                 #1"
043"SSI encoder not specified!\ MAchPar, S.3                  #1"
044"Value must be an integer multiple of 2! SSI               #1"
045"Res. length outside %d and %d!\                          \#1"
046"For singleturn the pulse train length should = Res. length  "
047"CAN data not fully programmed!\ MP                          "
048" Perm. output port no.: Local: 00; CAN: 01-04!\ NC program  "
049" Perm. input port no.:  Local: 00.01; CAN: 02-09!\ NC prog. "
050" Program: Value not in %s range!\ NC program                "
051"Error: error in configuration file CONFIG:DAT\              "
052" Save paramter only permissable with control inhibit aktiv!\"